Ducane Affinity S 3200 Guide De L'utilisateur page 19

TROUBLESHOOTING TROUBLESHOOTING
PROBLEM
IGNITION SYSTEM
MAIN GRILLING BURNERS
BURNERS WITH POOR FLAME
SIDE BURNER IGNITION DOES NOT
WORK.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.ducane.com.
CHECK and CURE
Be sure that there is gas fl ow to the burners by attempting to match light your burners.
If match lighting is successful, the problem lies somewhere in the ignition system and
will need to be checked.
CAUTION: Always turn the gas supply off at the tank before
proceeding with any troubleshooting procedures.
If, for any reason, the snap ignition fails to ignite the main grilling burner(s), repeat the
lighting procedures described on the grill control panel.
WARNING: The hood must be in the full open position any
time you attempt to light your grill. Failure to open the
hood could lead to delayed ignition resulting in bodily harm.
After shutting off the main gas supply, remove the cook grate and heat distribution
plates. Turn snap igniter counter clockwise and check if the electrode is sparking to the
igniter tube. Try the snap igniter several times.
Check to be sure burner ports, shutter, end of the burner (venturi) and orifi ce(s) are free
of any obstructions. Also, if your grill has been stored over a prolonged period of time,
check to make sure no spiderwebs have been formed in the shutter end of the burner
(venturi) or over orifi ces.
On an LP grill, if an extremely low fl ame is present, or is hard to ignite, the
fl ow-limiting device may have activated. To reset the fl ow limiter turn all burners control
knobs to "high". Wait at least 1 minute. Turn burner control knobs "OFF", reconnect the
regulator to the cylinder. Turn cylinder valve on slowly. Refer to Lighting Insructions.
Does burner light with a match?
IMPORTANT
If the main burner(s) still fails to ignite, make
sure that there is gas fl owing to the burner(s) by
attempting to match light the burner(s). If the
burners will match light, then proceed with the
ignition checkout.
If for any reason the igniter system is still
inoperative, follow match lighting instructions.
If you still have a poor fl ame, please contact
dealer for futher assistance or call Customer
Service
If match lights burner, check igniter (see
Sideburner Maintenance).
19