USING YOUR CLEANER
There are three working modes:
• STANDARD MODE: When you press ON-OFF switch, the cleaner is ready to clean thoroughly with the main motorised
nozzle. [3a]
NOTE: Standard mode is recommended to clean hard floors and above floors.
• CONTINUOUS MODE: To enable continuous mode you can pull switch lever back and it will click into place. To disable
continuous mode you can push the switch lever forward. [3b]
• TURBO MODE: Press the turbo button to fully power the product for hard cleaning tasks. [3c]
IMPORTANT: After each use of your product, please ensure to push the switch lever forward to the unlocked position.
Failure to do so may result in a reduction in battery life or failure.
SELECT SUITABLE ROLLER FOR BEST CLEANING
Intense Floor roller*: It is recommended to use on carpet which can go deep into the carpet to clean the dust.
Deep Care roller*: It is recommended to use on hard floor or delicate parquet. Thank to the soft bristles you can gently
clean those type of floors.
IMPORTANT: Always switch off the cleaner before changing and cleaning the agitator.
NOTE: To fit the Roller you would like to use: [17]
1. Detach the agitator release button flap. It is positioned on the lateral part of the nozzle.
2. Hold the agitator release flap and pull down to remove the agitator.
3. Replace with Intense Floor Roller or with the Deep Care Roller.
4. Re-fit in position the agitator release flap.
BATTERY
When the battery is discharging in normal use, the battery pack Led is white. When the battery capacity is lower than 5%,
the white Led light will begin to flash. [4]
When this happens you should stop cleaning and immediately recharge your battery, the Led will be red during the
charging. [1]
When charging the product, the continuous switch lever must be in the OFF position, it is also possible to charge the
battery pack when released from the product.
NOTE: If you are not going to use the cleaner for a long period of time, please remove the battery pack from the cleaner
to maintain the battery life.
WIPER BLADE ASSEMBLY
To obtain the best crevice and carpet performance, it is recommended to assemble the front and rear wiper blades to the
soleplate of the nozzle.
To do this, open the agitator release flap and remove the soft strip. Then grip one wiper blade, by inserting one end into
the rear slot and slide it in until fully home. Repeat these operations for the second wiper blade and slide it in the front
slot. Lock the agitator release flap. [5]
SAFETY PROTECTION SYSTEM
To ensure the reliability of the product is not affected if used under arduous conditions, the product features an integrated
safety protection system.
NOTE: The safety protection system will action if the agitator has a blockage or is locked, once actioned the agitator will
stop rotating, the white Led lights on the front of the nozzle will Flash 5 times. [6] If this happens, simply switch off your
product and clear the agitator obstruction. To resume cleaning, press the ON/OFF button and the product will restart in
normal mode.
* Certain Models Only
4
GB