Publicité
Display:
Once the product is turned on, all LED lights will light up for 3 seconds, and then the
refrigerator will operate to the default setting (LED3 light is on).
•
In the event of a failure, the corresponding LED light will blink.
•
If
there is no failure, it shows the actual temperature setting of the refrigerator.
Error Code
LED2 / LED4 flashing
LED1 / LED3 flashing
LED1 / LED2 / LED4 flashing
Temperature Setting:
Each time the temperature setting button A is pressed once, the temperature setting
changes one time. After the temperature setting has been completed, the refrigerator will
run according to the set value after 15 seconds.
Fast Cooling Mode:
• Long press the temperature
cooling" mode after 15 seconds, and LED1 and LED2 will light up at the same
time.
•
After running for 6 hours in "fast cooling" mode or if the setting button is
pressed or the temperature reaches 2°C, it will exit the "fast cool" mode and
then return to the previous setting
Stand-by Mode:
• Activation: Long press the temperature
enter standby mode, all charges are off, and the screen turns off.
• Disable: Long press the temperature
standby mode
NOTE:
• If the unit is unplugged, lost power, or turned off; you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the refrigerator will
not start.
• If you choose to change the thermostat setting, adjust thermostat control by one
numerical increment at a time. Allow several hours for temperature to stabilize
between adjustments.
Do not leave the door open for too long so that the indoor temperature does not rise
too much.
Description
Refrigerating temperature sensor fault
Ambient temperature sensor fault
Refrigerating defrost sensor fault
setting
.
button for 3 seconds, it will enter "fast
.
button
setting
button
setting
28
for 10 seconds to
for 10 seconds to exit
Publicité
