Télécharger Imprimer la page

Frigelux SP122BI Manuel D'utilisation page 22

Publicité

General safety
WARNING — This appliance is intended to be used in household.
WARNING — Do not store explosive substances such as aerosol cans with a flammable
propellant in this appliance.
WARNING — If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
WARNING — Keep ventilation openings, in the appliance enclosure or in the
WARNING — Do not damage the refrigerant circuit.
WARNING — Do not use electrical appliances inside the compartments of the appliance,
unless they are of the type recommended by the manufacturer.
WARNING — The refrigerant and insulation blowing gas are flammable. When disposing of
the appliance, do so only at an authorized waste disposal center. Do not expose to
Refrigerant
The refrigerant isobutene (R600a) is contained within the refrigerant circuit of the appliance,
a natural gas with a high level of environmental compatibility, which is nevertheless
flammable. During transportation and installation of the appliance, ensure that none of the
components of the refrigerant circuit becomes damaged. The refrigerant (R600a) is
flammable.
Caution risk of fire
If the refrigerant circuit should be damaged:
• Avoid opening flames and sources of ignition.
Thoroughly
It is dangerous to alter the specifications or modify this product in any way. Any damage to
the cord may cause a short circuit, fire, and/or electric shock.
Electrical safety
• We cannot be held responsible for any incident caused by poor electrical
installation. The power cord must not be lengthened. Make sure that the
power plug is not crushed or damaged. A crushed or damaged power plug
may overheat and cause a fire.
• Make sure that you can access the main plug of the appliance.
• Do not pull the main cable.
• If the power plug socket is loose, do not insert the power plug. There is a risk
of electric shock or fire.
• You must not operate the appliance without the interior lighting lamp cover.
• The appliance is only applied with power supply of single-phase alternating
current of 220~240V/50Hz. The device uses a wall socket earthed according
to current recommendations.
• If the power cable is damaged, do not proceed with his replacement but
contact your after-sales service.
ventilate the room in which the appliance is situated.
21
flame.

Publicité

loading