Publicité
User manual
I. Electric dryer
Congratulations on choosing VASCO GROUP nv. Our products have been
designed and manufactured in accordance with the applicable standards.
Read the manual to enjoy fault-free operation. Keep the
manual or download it from the manufacturer's website
at any time: www.vasco.eu
II. Safety requirements
Pay particular attention to the information contained in
this section. Not following the safety rules may
endanger life, health or property.
A. Safe installation of the electric dryer (Figures 2,
3, 4, 5)
1.
If a product has been purchased and the packaging shows signs of
mechanical damage or flooding, the buyer should claim this to the
seller. A damaged packaging may result in damage to the product,
which may be dangerous for the user.
2.
Install the appliance in accordance with the manufacturer's instructions
in this manual – paragraph II, VI.
3.
Installation of the appliance may only be carried out by a duly
authorised installer and connected to a correctly installed electrical
system - check the rating of the appliance.
ATTENTION! IEC 60364 specifies the allowed location and distance
from wet areas - including sinks, showers, bathtubs - to protect against
electric shock. (Fig.5).
4.
Any type of installation to which the appliance is connected should
comply with current regulations and standards.
5.
It must be ensured that the circuit in the electrical installation supplying
the appliance is equipped with an overcurrent and residual current
circuit breaker with a sensitivity of 30mA.
6.
Do not use any adaptors or extension cords to power the appliance.
7.
If the appliance is not equipped with a plug on the power supply cord or
with a means of disconnecting from the power supply having contact
breaks at all poles to ensure complete disconnection, such a switch
shall be installed in the fixed electrical installation in accordance with
the regulations applicable to such installation.
8.
The dryer must be mounted on the wall in accordance with the
manufacturer's guidelines.
B. Operation of the dryer
1. The product should only be used for the purpose for which it w as
intended by the manufacturer .
2. The appliance is not a toy.
3. Carry out regular inspection of the equipment to ensure its safe use (see
point VII)
4. If the non-detachable supply cord becomes damaged, it should be
replaced by a qualified person in order to a void any danger.
5. The manufacturer is not responsible for an y consequences resulting from
unauthorised interference inside the controller or constructional changes
made to the appliance by unauthorised persons.
6. Do not allow flooding of the electric dry er.
7. This equipment may be used by children of at least 8 years of age and
by people with reduced physical and mental capabilities and without
experience or knowledge of the equipment, if supervision or instruction
is provided on how to use the equipment safely so that the risks are
understood. Children should not pla y with the equipment. Unsupervised
children should not carry out cleaning or maintenance of the equipment.
8. Only carry out cleaning of the appliance when the electricit y supply is
disconnected.
9. Electric dryer can reach high temperatures - be careful when using the
appliance.
10. The power cable, if present, must not be o verstretched or bent, and
heavy objects must not be placed on it.
11. When drying towels and/or clothes, mak e sure that the washing agents
used and the material being dried do not ha ve any contraindications to
be dried at high temperatures.
C. Dealing with emergency situations
1.
An "emergency situation" is understood to mean:
· Appliance is burning or emitting smoke
· Appearance of electrical voltage on the dryers surface
2.
During an emergency situation, you should:
· Keep a safe distance
· Disconnect the appliance from the power supply, if this can be done
safely
· In the case of fire, contact the relevant emergency services or use the
fire-fighting measures described in point II.C.3.
· Contact a suitably qualified installer to remove the appliance.
· It is forbidden to reconnect the device to the power supply after an
emergency situation has occurred
· If the emergency did not occur by the fault of the user or the installer,
contact the VASCO GROUP service:
E-mail: info@vasco.be
3.
Permitted fire fighting agents
Appliance fires can be extinguished using fire fighting agents suitable
for electrical equipment fires with a voltage of up to 1000V.
The use of a carbon dioxide-filled extinguisher - a snow extinguisher -
is recommended.
III. Purpose (Figure 2)
A properly installed appliance is used for drying/warming towels in
rooms such as bathrooms, shower rooms, kitchens, etc. The appliance
should be installed in rooms with normal humidity, where there are no
factors causing faster corrosion.
IV. Technical data (Figures 1, 6)
Table 1. Technical data
Type
Spike mini
Dimensions (fig 1)
85x915x92[mm]
Power supply
~230V, 50Hz
Power
20W
Insulation class
Class I - this means that the connection
socket or connection cable has a protective
earthing cable. It is necessary (required) to
connect the appliance to an installation or
socket fitted with a proper protective
terminal.
Type of connection
Permanently connected appliance
Housing protection
IPX4
rating
The product complies
- Directive 2014/35/UE (LVD)
with
- Directive 2011/65/UE (RoHS II)
Year of production
See first 2 digits of the serial number (fig. 6)
V. Structure (Figure 3)
1. Dryer collector
2. Hanger – 1 pc (Spike mini) or 2 pcs (Spike)
3. LED indicator
4. Switch - on/off
5. Place of power cord mounting
6. Screws for fixing hanger bases and head to the wall
7. Grub screws fixing the head or hanger to the base
8. Hanger base – 1 pc (Spike mini) or 2 pcs (Spike)
9. Head base fixed to wall or installation box
10. Mains connection terminals
11. External supply cord (optional equipment)
12. Dryer head
VI. Installation (Figures 2, 3, 4, 5)
Pay particular attention to the information contained in
this section. Not following the safety rules may
endanger life, health or property.
Spike
85x1515x92[mm]
35W
English
- 9 -
Publicité
