Operation - Stile CF0110 Guide D'installation

OPERATION

USING THE REMOTE CONTROL
NOTE: If you have not already done so, restore power to
the room and wall switch, then make sure the wall switch
controlling the fan is turned on. The remote control will have
no effect on the fan if the switch is turned off.
 Install the two AAA batteries provided into the remote
control.
AAA BATTERY
REMOTE CONTROL
 To turn the light on and off, press and release the
ton. Press and hold the button to control the brightness
of the light.
NOTE: The brightness of the fan light can only be con-
trolled by the remote control. A wall-mounted dimmer
switch will not change the light's brightness.
 To set the fan speed, press the desired speed button.
 To turn the fan OFF, press the OFF button.
+
+ AAA 1.5V
AAA 1.5V +
+
REMOTE CONTROL
BATTERY COVER
but-
16 - English
To mount the remote control holder:
 Remove the screw cover from the remote control holder.
 Install the remote control holder in the desired location
using the two mounting screws provided.
 Replace the screw cover to cover the screw heads.
MODEL NO: UC7216T
FCC ID: CHQ7216T
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this de-
vice must accept any interference received, including inter-
ference that may cause undesired operation.
SCREW COVER
REMOTE CONTROL
HOLDER
SCREWS