Installation - Stile CF0110 Guide D'installation

INSTALLATION

INSTALLING THE CEILING FAN MOUNTING
BRACKET ASSEMBLY
 The mounting bracket assembly, canopy, and the canopy
screw cover ring are assembled together for shipping
purposes. If you haven't already done so, separate these
pieces now.
• Twist the canopy screw cover ring counterclockwise
to release.
• Loosen the two screws over the slots in the canopy.
• Remove the two screws securing the canopy to the
mounting bracket assembly, then twist the canopy
counterclockwise to release from the other two screws.
SCREW OVER
CANOPY SLOT
SCREW
CANOPY SCREW
COVER RING
CANOPY
MOUNTING
BRACKET
SCREW
SCREW OVER
CANOPY SLOT
 Remove any existing ceiling fan or light where you intend
to install this ceiling fan. Verify the existing outlet box is
marked acceptable for fan support up to 35 lbs. and that
it is securely fastened to the ceiling joists.
OUTLET
BOX
For Canada installations, refer to the Canada
Installation Addendum located in the Canada
Installation Hardware Bag and install the eye
bolt or anchor assembly now.
 Using the screws provided with the outlet box, attach the
ceiling mounting bracket assembly to the electrical box,
passing the 120V electrical supply wires through the hole
in the center of the mounting bracket assembly.
NOTE: If you are installing the mounting bracket assembly
for an angled orientation, make sure the open end of the
bracket is installed facing the lower point of the ceiling.
7 - English
CEILING
MOUNTING
BRACKET
SCREW