LiftMaster CAP2D Manuel D'instructions page 5

INTRODUCTION
Carton Inventory
• Door Controller
• USB Cable
• Diodes
• Installation Manual
Tools Needed
• PH2 Phillips Screwdriver
• Precision 1/8" Flat or PH0 Phillips Screwdriver
• 1/4" Nut Driver
• Drill/Driver
• 7/64" Drill Bit
• Hammer Drill Bits for Drill/Driver
• RJ45 Crimping Pliers
• Multimeter
• Measuring tape
• Conduit Bender
• Conduit Cutter/Reamer
• Hack Saw
• Center Punch Tool
• Hammer
Dimensions
PRE-INSTALL WIRING
3" (7.6 cm)
NETWORK ACCESS CONTROL
4-1/2" (11.4 cm)
1-1/4" (3.2 cm)
5
INSTALL
.36" (.9 cm)