LiftMaster CAP2D Manuel D'instructions page 4

INTRODUCTION
Controller Overview
STATUS LED
Solid: System has power
Control Board Overview
ADMINISTRATIVE USB
POWER CONFIG
JUMPER
EXTERNAL 12V POWER
BACKUP LITHIUM COIN BATTERY
(CR1220)
Control Board Connection
Administrative USB
LAN/PoE
Backup Lithium Battery
Local Heartbeat
Relay Indicator
Power Configuration
*NOTE: Compliance to IEEE 802.3, at or af, was not evaluated by UL.
PRE-INSTALL WIRING
Auxiliary Relay 1
Aux Relay 1 LED
Primary Relay 1
Relay 1 LED
Auxiliary Relay 2
Aux Relay 2 LED
Primary Relay 2
Relay 2 LED
Connect Mini-USB cable to access administrative functions
Connect to network. *May also carry 802.3af/at power
Battery preserves the system's data during primary power outages
LED indicates proper function
LED lights when relay is engaged (one per relay)
Jumper selects between PoE or Wired Power Supply
NETWORK
FRONT VIEW
ACTIVE LED
OFF/Solid: System is starting
Blinking: System operational.
NC
COM
NO
NC
COM
NO
NC
COM
NO
NC
COM
NO
Description
4
ACCESS CONTROL
NETWORK LED
Orange LED: 100MBit Link
Blue LED: Network activity
Right Blue LED: Good connection to the network
LAN/PoE Connector
REQUEST TO EXIT
STATUS 1
WIEGAND INPUT 1
REQUEST TO EXIT
STATUS 2
WIEGAND INPUT 2
LOCAL HEARTBEAT LED
INSTALL