Publicité
10
Glass
Raise glass, aligning threaded rod on light
fixture with the hole in the middle of the
glass and push up gently allowing threaded
rod to come through the hole.
1. Check blue wire from fan to make sure it is connected to hot wire from house.
2. Check for loose or disconnected wires in fan switch housing.
3. Check for loose or disconnected wires in light kit.
4. Check for faulty light bulbs.
5. The intensity of the light can be very weak and you can barely see the light beam, or might see tiny
flickers when it is dimmed to a low level (If the light kit includes a dimmer or light controller). Adjusting the
light intensity with the dimmer (light controller) can fix it.
WARNING: Make sure main power is turned off before entering switch housing.
WARNING: This fixture is equipped with a wattage limiting device. Over lamping the fixture will result in the
lights shutting down and may damage the wattage limiter. Turn power off and replace with a proper wattage
of lamps.
Replacement lamps are available, please call customer care center.
© 2016 Monte Carlo Fan Company
11
Align hole in center of final cap with thread
rod, allowing pull chains to come through
appropriate holes in the final cap, and push
up. Thread center pull chain through hole in
finial and secure glass to light fixture by
tightening the finial. DO NOT OVER TIGHTEN
the finial as glass may crack or break.
TROUBLESHOOTING
4
12
Pull chain
Install fan and light kit pull chains to
preassembled pull chains on fan and light
kit. Pull chains provided.
12/2016
Publicité
