Publicité
CAUTION: To reduce the risk of fire and electric shock, this light kit should be used only with 5COM52XX
,5HS42XX, 5OR52XX, 5TLR54XX series fans manufactured by Chien Luen Industries (Zhongshan) LTD.
To assure success of this installation be sure to read the instructions and review the diagrams thoroughly
before beginning. Follow the instructions that are applicable for your light kit.
Review the installation instructions supplied with your fan. Make sure that your fan has been installed and
wired properly to allow use with your light kit.
All electrical connections must be in accordance with local codes, ordinances, and national electrical
codes. Use AC 120V/60HZ power supply only.
If you are unfamiliar with methods of installing electrical wiring, secure the services of a qualified
electrician.
WARNING: Risk of electrical shock. Before starting installation, disconnect the power by turning off the
circuit breaker or removing the fuse at the fuse box. Turning the power off using the fan switch is not
sufficient to avoid electrical shock.
WARNING
Lamp may not be compatible with all controllers, do not use this fixture with any unverified
:
solid state fan/light control devices, or dimmers.
NOTE: The important safeguards and instructions appearing in this manual are not meant to cover all
possible conditions and situations that may occur. It must be understood that common sense, caution and
care are factors that cannot be built into any product. These factors must be supplied by the person(s)
caring for and operating the unit.
NOTE: For normal installation, please use the plug system to install light kit. Figure A.
For installation where the fan doesn't have a plug system, remove plugs (cut off plugs with scissors or
wire cutters) and wire lead wires from source to lead wires from light kit. Install wire nuts to all
connections making sure no filaments are exposed. Figure B
Use remote control that comes with fan to control up light and down light separately when used with fan.
If the light kit is available with Semi Flush Mount, use wall switch when the light kit is installed with semi
flush mount.
Note: Suitable for use in damp locations.
Fig. A
© 2016 Monte Carlo Fan Company
Cautions and Warnings
Plug system
Customer Service Center
www.montecarlofans.com
GENERAL
Fig. B
Customer Service
800-969-3347
7400 Linder Ave.
Skokie, IL 60077
2
Non plug system
12/2016
Publicité
