Publicité
13
Installation Method 5: Use on-ceiling accessories (optional)
ceiling has a load-bearing capacity less than 1.0KG, you can choose this method.)
1. Drill two holes in the ceiling to install the suspend pole adapter. If the
network cable is from inside the ceiling, drill one hole for passing the cable
(Φ21mm). And then insert expansion anchors.
2. If the Ethernet cable is from inside the ceiling, passing the cable trough
the hole in the ceiling and then through the pole adapter. If the Ethernet
cable is on the side, pass the cable through the slot of the pole adapter
and then through it.
3. Secure the pole adapter in place.
4. Assemble the mounting ring and dust cover into a single unit.
5. Connect the Ethernet cable and attach the dust cover to the device.
41.8mm
4
Connection Sample
(If your
3x HDMI out
MTouch
Mcore Pro
PoE+Switch
Display
MTouch Plus
14
6. Tighten the mounting ring to the mounting base.
7. You can adjust the orientation of the CM20 to 0 degrees by twisting the
middle adapter bracket. And install the magnetic grille. After adjustment,
fix the connection with screws to achieve good pickup performance for
the CM20.
8. Attach the mesh cover to the CM20.
Verify the orientation of CM20.
UVC86
UVC86
AVHub
CM20
CM20
CS10
CS10
fix with a screw
Attach the mesh cover.
Publicité
