Publicité
1
E
1
Package Contents
N
Φ215*H81mm
White Mesh Cover
CM20
(Black Optional)
Length-Adjustable Pole
Assembly Fixing
（Optional）
Dust Cover
Suspend Pole Adapter
On-ceiling Component
M3*6PWMHOZN3
(Optional)
× 8
φ6 * 30 mm, white, Polyamide
（Optional）
Quick Start Guide
3
3
Installation
• Remove the ceiling and draw auxiliary lines at the midpoint of the length
and width on the back of the ceiling.
• Align the auxiliary lines with the deployment instruction templete's
guidelines and cut openings in the ceiling.
• Opening diameter: 200-205mm; Opening depth: 80mm.
D=223mm
Deployment Instruction
Templete
D=205mm
Bracing Bridge*2
Bracket
Suspension rope assembly
（Optional）
（Optional）
× 5
× 20
3*6PMOZN3+
2
The need for an auxiliary bracket during the installation of the CM20 depends mainly on the frame
and the load-bearing capacity of the suspended ceiling tiles.
- Common suspended ceiling tiles materials include gypsum, metal, and PVC.
- If your suspended ceiling tiles has a load-bearing capacity lower than 1.38KG, it is recommended
to use a bracing bridge.
- The suspension bracket requires the load-bearing capacity of your ceiling frame to be no less
than 2.8KG.
- The adjustable range of the bracing bridge is 400-438mm/600-638mm/2'.
- The slot width compatibility of the ceiling tiles (T-bar) includes: 22mm, 24mm, 32mm, and 38mm.
- The slot width compatibility of the ceiling tiles (triangle) includes: 25mm, 30mm, 35mm.
- The adjustable range of the length-adjustable pole is 33cm-60cm.
1. The installation of CM20 requires a certain level of professional expertise. We strongly
recommend entrusting this task to professional construction workers whenever possible.
2. If you choose to install it yourself, please make sure to have someone assist you for safety
reasons.
2
Hardware Introduction
× 4
× 8
T4*30mm
（Optional）
4
Installation Method 1：
has a load-bearing capacity greater than 1.38KG, you may choose not to use the
bracket for additional support, but the
1. Place the assembly fixing bracket onto the drop ceiling grid support (compatible with
T-bar drop ceiling grid and triangular drop ceiling grid).
2. Connect the ethernet cable and cover it with the dust cover.
3. Install CM20 along the opening circular of the drop ceiling grid, pushing it towards
the ceiling.
4.Hold the device by hand and securely tighten the three screws on its surface in a
clockwise direction. Adjust the lower surface of the CM20 to align it flush with the
ceiling tiles.
Power supply: PoE+Switch
RJ-45 Port
Reset(Long poke for 5s to reset.)
Use the assembly fixing bracket
assembly fixing bracket
is still necessary.)
1
2
(If your ceiling
Publicité
