Publicité
MANUAL - STREET-WAVE
LCD screens and flash intermittently.
Press the « » button on either one of the speakers for 5 seconds. Both units will enter pairing mode.
•
•
One of the units will show the word « BLUE » on the LCD display. This is the master unit and will act as the left
channel, while the other one will be the slave unit and will act as the right channel.
•
Go to your phone's Bluetooth interface and select « STREET-WAVE » from the list of available devices. If pai-
ring is successful, the word BLUE on the master unit will stop flashing.
•
To disconnect the speakers, select any other mode on either one of the speakers.
TROUBLESHOOTING
Problem
Possible cause
No sound when
1: No input sound source
power on
2: Volume knob in the lowest position
3: USB/SD no plug
Distortion of
1: Volume too loud
2: Audio file error
sound
No sound from
1: Microphone socket not fully
the Microphone
plugged in
2: Microphone switch is not on
3: Microphone volume too low
No sound from
1:i ncompatible song format
the USB/SD card
2: Illegal copy causes failures
3: USB/SD Card not inserted properly
Speaker makes
1: Wired Microphone too close to the
noise
speaker
2: Wired Microphone is switched on
but not in use
3: Microphone volume too loud
4: Mobile phone too close to the
speaker
5: Too close to the equipment which
interferes with the speaker
Bluetooth con-
1: Bluetooth disconnected
nection fails
2: Bluetooth connected but no voice
3: Bluetooth distance too short
SPECIFICATIONS
Max. power .............................................................................................................................................400W
Consumption .............................................................................................................................................50W
Woofer ................................................................................................................................................8"/20cm
Tweeter ..............................................................................................................................................3"/7.5cm
Freq. range ....................................................................................................................................50Hz-18kHz
S/N ratio ................................................................................................................................................ ≥70dB
Power supply ................................................. 15V�� 3.6A via supplied 100-240V~ (±10%) 50/60Hz adaptor
Built-in battery ..............................................................................................................Lead-acid 12V�� 4.5Ah
Charging time ...................................................................................................................................5.5 hours
Playing time ......................................................................................................................................3-5 hours
Bluetooth frequency band........................................................................................................2402-2480MHz
BT max. RF emission power ...............................................................................................................0.50dBm
Dimensions ......................................................................................................................290 x 280 x 545mm
Weight .................................................................................................................................................. 11.5kg
Solution
1: Connect a Line signal
2: Adjust volume
3: Insert a USB/SD Card
1: Reduce volume
2: Check and change the audio file
3: Adjust Bass/Treble via "MENU" and "Main volume"
1: Completely plug in the microphone socket
2: Power on microphone
3: Adjust microphone volume
1: songs format should be MP3/WMA
2: Power off, then power on
3: Insert USB/SD card properly
1: Do not let the wired microphones head point at
the speaker
2: Turn off wired microphone if not in use
3: Reduce the microphone volume
4: Keep mobile away from the speaker during calls
5: Keep the speaker away from other sources of
interference
1: Find the right device Name or press "MENU" But-
ton to restore factory settings.
2: Confirm if you are connected to the right device
Name
3: Try to keep away from barriers, such as walls,
glasses...etc
www.ibiza-light.com
5
Publicité
