Delta 50-720 Manuel D'utilisation page 8

HOW TO ATTACH THE MOTOR AND BLOWER ASSEMBLY TO THE FRAME
1. Place the motor assembly and base assembly on their sides.
2. Align the eight holes (A) Fig. 5 on the top of the side supports with the eight holes in the motor assembly.
3. Place a 5/16" lockwasher on a 5/16-18 x 5/8" hex-head screw.
4. Insert the bolt thru the side support. Thread it the tapped hole in the motor assembly. Tighten securely.
5. Repeat this process for the seven remaining holes.
The motor and blower assembly attached to the
side supports is illustrated in Fig. 6.
HOW TO ATTACH THE SUPPORT
1. Place the support (A) Fig. 7 inside the two side supports (B).
NOTE: Attach the support to the side supports nearest the motor.
2. Align the four holes in the support with the four holes in the side supports.
3. Insert a 5/16-18 x 5/8" hex-head screw (A) Fig. 8 through the side supports and the support.
4. Place a 5/16" lockwasher on the hex-head screw.
5. Thread a 5/16-18 hex nut on the hex-head screw and tighten securely.
6. Repeat this process for the three remaining holes for attaching the support.
7. Fig. 9 shows the support attached to the side supports.
Fig. 7
B
A
Fig. 5
A
Fig. 8
B
A
B
8
C
Fig. 6
Fig. 9