DeWalt D28710 Guide D'utilisation page 8

Standard Equipment
1 14" (355mm) metal cutting abrasive wheel
1 Wheel wrench
1 Instruction manual
To Carry (Fig. 1)
Fold down unit to position where you can carry the saw. Use the chain
lock (A) to lock arm down.
Unlocking (Fig. 1)
To unlock tool and raise head, depress motor arm slightly and unlock
the chain lock (A). Motor arm will then pivot upward.
Material Clamping and Supporting
• Angles are best clamped and cut with both legs resting against
base.
• A spacer block slightly narrower than the workpiece can be
used to increase wheel utilization (Fig. 2).
• Long workpieces must be supported by a block so it will be level
with top of base (Fig. 3). The cut-off end should be free to fall
downward to avoid wheel binding.
DIAMETER OF WORKPIECE
FIG. 2
F
WIDTH OF SPACER BLOCK
Spark Defl ector Adjustment (Fig. 1)
To best deflect sparks away from surrounding persons and
materials, loosen the screw (B), adjust the spark deflector (C) and
then retighten screw. Do not allow cordset to come into contact with
deflector or sparks as damage to cordset may occur.
FIG. 4
E
SPACER
BLOCK
6 6
FIG. 3
BLOCK
E
Q
FORWARD
F
CUT-OFF END
I
H