Lutron CTCL-150 Guide D'installation Rapide

Quick Install Guide
How-to videos
lutron.com/wiringwizard
CTCL-150, LECL-150
CFL
LED
LFCA
DEL
AFC
150 W
600 W *
LED / CFL
Incand. / Hal.
Please read before installing
English
WARNING: SHOCK HAZARD. May result in serious injury or death.
Turn off power at circuit breaker or fuse before installing.
Black
Black
Green
AFTER INSTALLATION: Adjust dimming range for CFLs and LEDs
1. Turn lights ON and move slider to bottom.
2. Adjust lever to improve dimming. NOTE: The Adjustment Lever on your
dimmer may be in a different location than shown.
3. Turn lights OFF and ON to verify proper operation.
For Troubleshooting, please visit www.lutron.com/support
Limited Warranty: www.lutron.com/TechnicalDocumentLibrary/369-119_Wallbox_Warranty.pdf
Lutron and LED+ are trademarks or registered trademarks of Lutron Electronics Co., Inc., in the U.S. and other countries. The YouTube icon is a trademark of Google LLC.
Receive an Extended Warranty: www.lutron.com/CLregistration
Support: 1.844.LUTRON1 (USA / Canada)
LED + Dimmer
Install with
confidence
Use included diagrams
or visit our website for
step-by-step instructions.
Ganging and Derating
Remove side sections if mounting
two or more devices side by side
(see chart for new wattage rating).
* Maximum Allowable Inc. / Hal. Wattage
No sides 1 side removed
removed
600 W
Bend back
and forth
INSTALL WITH CONFIDENCE
VIDEO & STEP-BY-STEP INSTRUCTIONS VIDEO & STEP-BY-STEP INSTRUCTIONS
l u t r o n . c o m / w i r i n g w i z a r d
Ground (bare or green)
120 V~ 60 Hz
2 sides removed
500 W 400 W
Connect
NOTE: Black wires are interchangeable.
©2013–2020 Lutron Electronics Co., Inc.
+1.888.235.2910 (Mexico)
®
P/N 0301957 REV A
Find the right LED
l u t ro n . c o m / L E D f i n d e r
Important Notes
1. CAUTION: Use only with permanently installed fixtures with
dimmable screw-in compact fluorescent, dimmable screw-in
LED, halogen, or incandescent lamps. To avoid overheating
and possible damage to other equipment, do not use to control
receptacles, motor-driven appliances, or transformer-supplied
appliances.
2. Install in accordance with all national and local electrical codes.
3. When no "grounding means" exists in wallbox, the National
Electrical Code (NECR) allows a control to be installed as a
replacement when a plastic faceplate with plastic fasteners
is used, or the circuit is protected by a ground fault circuit
interrupter (GFCI). Lutron wallplates meet this requirement. Cap
or remove green wire before screwing control into wallbox.
4. Protect the dimmer from dust and dirt when painting or
spackling the wall.
5. It is normal for the dimmer to feel warm to the touch during
operation.
6. Clean the dimmer with a soft damp cloth only. Do not use any
chemical cleaners.
7. For indoor use only.
5