Publicité
EN
Safety Instructions
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your BUFFALO product.
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove any
components on this product.
• Consult Local and National Standards to comply with the
following:
- Health and Safety at Work Legislation
- BS EN Codes of Practice
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
• Ensure the location for the unit can support its weight when full.
• DO NOT fill the appliance above the 'MAX' level.
• DO NOT immerse the appliance in water.
• DO NOT leave the machine unattended during operation.
• DO NOT operate this appliance when less than one third full.
• Danger of burns - Do not touch hot surfaces and
beware of escaping steam.
• For indoor use only. Do not use outdoors or under
extremely cold conditions. Freezing up of the unit may pose a
safety hazard.
• Always switch off and disconnect the power supply to the
appliance when not in use.
• Keep all packaging away from children. Dispose of the
packaging in accordance to the regulations of local authorities.
• If the power cord is damaged, it must be replaced by a Buffalo
agent or a recommended qualified technician in order to avoid
a hazard.
• Please ensure that the tap is screwed fully on before use.
• Buffalo recommend that this product is connected to a circuit
protected by an appropriate RCD (Residual Current Device).
2
CU547-CU549_CJ549_ML_A5_v8_20241016.indb 2
CU547-CU549_CJ549_ML_A5_v8_20241016.indb 2
2024/10/16 15:38
2024/10/16 15:38
Publicité
