Publicité
Installation Instructions
Installation
1-1
Disconnect Negative (-) battery cable from the battery
sensor terminal. Hold the battery sensor carefully when
removing the 10mm nut.
1-3
Clip
J Nut
and
Bolt
Install J-Nut into bumper cavity at the pre-arranged
location. Make sure the threaded side is pointing toward
the outside (front). Insert lamp assembly into bumper
cavity from behind the bumper. Install clip and bolt.
Torque bolt to 7.5Nm (5.5 ft lbs)
Plug in lamp connector, ensure the tab locks into place
Description
2020 Legacy Fog Lamp Kit
Part Number: H451SAN000
Description: Fog Light Kit, Legacy
1-2
Remove three (3) clips and pull down the fender liner.
Free fog lamp harness connector from the breakaway
tape.
Remove two phillips screws and fog cover blank.
1-4
Reassemble fender liner.
Repeat install for remaining side of vehicle
Issue
Date
1
4/3/2019
Subaru of America
Page
2 / 4
Publicité
