Publicité
Clutch Lever B - Activation of brush.
To operate the black brush lever in Fig. 7, the red
control stick must first be activated. By tilting the red
stick completely to the right and then push the lever
down activates the brush.
Important! The red control stick on the clutch lever
must be pushed to the far right / left before the clutch
lever is activated. If not the clutch lever will forced of its
hold. If this happens, push the lever back up and
repeat the procedure. See Fig.7C.
Note: The clutch lever is not broken but simply pushed
back into place.
The sweeper is equipped with a "dead man's handle",
once released the brush and drive will stop
immediately.
Operation safety zone
Do not leave the operation safety zone marked in fig 9,
while working with the machine. If it is necessary to
leave the operation zone, for example to readjust the
rotary brush or to attach an accessory, first stop the
engine.
Height adjustment of brush
When the brush becomes worn, it might be necessary
to adjust the proximity of brushes to the working
surface. To adjust the height of the brushes follow
figure 8:
1. Remove the lock pin
2. Lift the front of the machine to free the brush
and pull the supporting wheels out.
3. Remove or add the spacer ring
(1 ring = approx. 5 mm)
4. Install support wheels, remove / add spacer
ring, fasten with locking pin.
(Hint: Complete one wheel at a time)
Angle adjustment of brush
The brush can be pivoted 20 degrees to either side.
This is done by pushing the swing handle down,
turning the brush and releases the handle so the
detent clicks into place.
The swing handle is shown on Figure 2, item J
Height adjustment of handle
Adjust the handle such that the working height is
comfortable. Use the hand wheels on each side of the
handle bar. Figure 3, C.
Technical specifications
Model
Total width (mm)
Working width (mm)
Weight w/o fuel (kg)
Brush diameter (mm)
Swinging brush
(positions)
Speed (km/h)
Tire size
Tire pressure (psi)
Model
Total width (mm)
Working width (mm)
Weight w/o fuel (kg)
Brush diameter (mm)
Swinging brush
(positions)
Speed (km/h)
Tire size
Tire pressure (psi)
Troubleshooting
Problem Solution
The engine won't start:
1. Check sparkplug.
2. Check that the spark plug cap is fitted
correctly.
3. Check if the motor is equipped with an
ignition switch.
(It must be activated)
4. Check if the motor is equipped with a
fuel valve.
(It must be activated)
The engine runs unevenly:
1. Check that the choke has been released.
2. Check fuel for impurities.
If the brush will not run:
1. Check that the clutch is adjusted
correctly.
2. Check that the belt is tight.
If the machine will not run:
1. Check that the clutch is adjusted
correctly.
2. Check the belt.
If the machine does not sweep effectively:
1. Check the distance between the brush
and working surface.
13
HS600TG HS600B HS600TGE
650
650
600
600
66
66
66,5
350
350
3
3
3
3
3.0 x 10
3.0 x 10
3.0 x 10
30
30
HS700TG HS700B HS700TGE
700
700
700
700
68
68
68.5
350
350
3
3
3
3
4.10 x 4
4.10 x 4
4.10 x 4
30
30
650
600
350
3
3
30
700
700
350
3
3
30
Publicité
