Publicité
B
Product usage
Connect the water supply inlet hose
1.
If the water inlet hose is not already installed, it must be screwed to the appliance. The
blue marked hose is only for cold water.
2.
Screw by hand the inlet hose onto the tap, tightening the nut.
Attention:
•
No kinks in the hose!
•
The appliance must not be connected to the mixing tap of an un-pressurized
water heater.
•
Check water-tightness of connections by turning the tap completely on.
•
If the hose is too short, replace it with a suitable length of pressure resistant
hose (1000 kPa min).
•
Check the inlet hose regularly for brittleness and cracks and replace if
necessary.
•
The washing machine can be connected without a non-return valve.
Connect the drain hose
In case the drain hose is installed as shown below:
1.
Unhook it only from the right clip (see arrow)
10
EN
Publicité
