Utilities - tecnotest 3167 Manuel D'utilisation


BATTERY TESTER_________________________________________________________________________
4. When finished, press the MENU key. This displays a reminder message and then
displays the main menu, as shown below.
5. Turn off the amp probe. To do this, follow the instructions in "AMP PROBE
SETUP" on chapter 4.2. At step 4, press the Down Arrow key to set the amp
probe's status to DISABLED.
6. Select another test or disconnect the clamps and the amp probe from the battery.
7. Press the OFF key to turn the tester off (the tester turns off automatically after a
few minutes of inactivity).
5.0 -

UTILITIES

This chapter includes the following sections:
•
Set Time / Date.
•
Software Update.
•
Unit Version.
•
Test Counters.
•
Edit Header or Footer.
•
Amp Probe Setup.
•
Stored Tests.
NOTE:
Because the tester shuts off automatically after a few minutes, it may be helpful to
connect the tester to a battery before performing the steps in this chapter (to do this,
refer to "Pretest Steps" on chapter 3.1.)
58
REMEMBER
TO TURN OFF THE
AMP PROBE
OUT OF VEHICLE
IN VEHICLE
QUICK TEST
MULTIMETER
GO
OPERATING INSTRUCTIONS