Publicité
AMPLIFIER
Place amplifier on shelf. Read separate amplifier
instructions below.
GOOSENECK MICROPHONE
1.
Plug male end of microphone cable into the
microphone jack labeled "dynamic."
2. Take female end of microphone cable; and starting
at amplifier, route cable up through opening in
microphone mount in reading surface.
3. Plug microphone into microphone cable. Push
microphone and cable back into the microphone
mount as needed. (See Figure 8)
Figure 8
Microphone
Mount
Amplifier
Before using product, read manual for important safety
information. Retain instructions for future use.
CAUTION! Device should only be serviced by
qualified personnel.
CAUTION! Do not attempt to modify device in
any way, as this could invalidate warranty.
CLEANING
Clean amplifier with soft, dry cloth.
CAUTION! Never use benzene, paint thinner or
other chemicals to clean device.
PAGE 3 OF 21
ASSEMBLY CONTINUED
Gooseneck
Microphone
Microphone
Jack
POWER
MICROPHONE
AUX
PRESS FOR
MAIN
1
SIREN
ON
VOLUME
DYNAMIC
VOLUME
2
3
ON
OFF
DC IN
DC OUT
CONDENSER
WIRELESS
LINE IN
WIRELESS
AMPLIFIER INSTRUCTIONS
SPEAKERS
Looking inside of cabinet, view backside of speaker
enclosure. Unwrap speaker wires and bring them to the
front of the amplifier. Plug them into the speaker jacks
marked "L - SPEAKER - R." (See Figure 9)
Figure 9
OUTPUT
TONE
L–SPEAKER–R
LINE OUT
LOCATION
Place amplifier in stable location, as amplifier falling
may cause damage to device or bodily harm.
INTENDED USE
Amplifier may only be used with original parts. Intended
use includes adherence to these installation instructions.
Uline accepts no liability for damage due to improper
use.
MIC
POWER
PRESS FOR
MAIN
1
Speaker
SIREN
ON
VOLUME
DYNAMIC
VOLUME
WIRELESS
WIRELESS
2
3
Wires
ON
OFF
DC IN
DC OUT
CONDENSER
WIRELESS
LINE IN
Amplifier
Speaker
Jacks
AUX
OUTPUT
TONE
L–SPEAKER–R
LINE OUT
1224 IH-7826
Publicité
