Publicité
Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
13. ENERGY SAVING TIPS
•
Install the appliance in a dry, well-ventilated room away from heat sources (radiator, cooking surface and so on) and in a position
out of direct sunlight.
•
Follow the installation instructions to ensure adequate ventilation. Insufficient ventilation to the back of the appliance causes an
increase in energy consumption and reduces cooling efficiency.
•
The internal temperature of the appliance depends on the room temperature, how often the doors are opened and where the
appliance is placed. These factors have to be taken into account when setting the thermostat. Only open the doors when strictly
necessary.
•
Let hot food and drink cool down before placing them in the appliance.
•
The positioning of the shelves in the fridge has no effect on energy efficiency.
14. MAINTENANCE
WARNING! Maintenance must be carried out by technical staff trained and enabled for intervention
on the flammable refrigerants.
WARNING! Any work carried out on the appliance by the user strictly requires the power plug being
disconnected from the mains socket.
ATTENTION! Use protective shoes and gloves during maintenance operations.
Special maintenance
The instructions given in the following paragraph can be followed from qualified technicians
•
Periodically clean the condenser using suitable tools (vacuum cleaner or soft brushes) can extend the
life of the appliance.
•
Check that the electrical connections are not loose.
•
Check that the thermostat and the sensor are in proper working order.
15. CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE POWER
PLUG BEFORE CLEANING.
For a good preservation of the cabinet's body a periodical cleaning is necessary.
1. EXTERNAL BODY:
solution.
2. STAINLESS STEEL SURFACES:
scouring pads etc. which will spoil the finish of the stainless steel.
3. SURFACES IN PLASTIC MATERIAL:
under no circumstances should alcohol, methylated spirits or solvents be used.
1.
Clean the enclosure and interior of the appliance as often as possible.
2.
Clean the unit with moist cloth. Never allow the switch, control panel, cable or plug to get wet.
3.
Do not use abrasive cleaning agents. These can leave harmful residues. Use only mild soapy water.
4.
Clean the door seal with water only.
5.
Ensure that no cleaning water penetrates into the electrical components.
6.
Must not be cleaned by a water jet.
7.
Always wipe dry after cleaning with soft cloth.
8.
Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
9.
Take care when cleaning the rear of the appliance.
10. An agent or technician must carry out repairs if required.
11. If the appliance is to be left inactive for long periods, unplug the appliance after having turned the switch to OFF position,
empty the refrigerating compartment and clean thoroughly.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
WARNING! Do not use jet of water to clean the cabinet: electrical wiring could be damaged.
WARNING! Never use mechanical devices or any other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
STOK 701 P / STOK 701 N
STOK 1401 P / STOK 1401 N
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
When necessary, the external body should be cleaned with a cloth and a neutral soap and water
Wash with warm water and mild detergent, rinse well and dry with soft cloth. Avoid
Wash with warm water and mild detergent, rinse well and dry with soft cloth;
1 8 / 5 6
PAGE
N° DOC
Publicité
