Publicité
Liens rapides
For Stair Railings
A Veranda Stair Rail Kit
makes it easy to construct
stair railings, using drilled rails
and 3-step, 4-step or 5-step
pre-manufactured pressure treated
stair stringers.
Installation
1
Install deck posts to support the railing on the
top and bottom landings of the stairs. Spacing
from inside edge to inside edge should be a
maximum of 6' for pressure treated posts and
a maximum of 3' 7" for cedar posts. The actual
spacing will depend on how the deck post is
fastened to the deck. Consult local building
codes or a recognized building professional.
Stair Rail Kit
2
Ensure that posts are plumb before beginning. Lay a drilled
rail with the holes facing up on the stair treads and centre it
against the posts for the bottom rail. Check that the space
between the last hole and the post at either end are equal.
Draw a line along the face of the rail where it meets the
upright post [Figure 1]. Then, subtract 1/4" from each end
to allow for clips and draw a new line [Figure 2].
Figure 1
Figure 2
3
Mark the left edge of the centre holes in both the top and
bottom rail [Figure 3]. The drilled holes in the bottom
and top rails must be exactly aligned to install the
balusters vertically plumb.
Figure 3
C
1/4"
681548_Veranda_StairRailKit_Round_2014_V2
1/4"
Publicité
Sommaire des Matières pour Veranda 681548
- Page 1 [Figure 2]. Figure 1 1/4" Figure 2 1/4" A Veranda Stair Rail Kit makes it easy to construct stair railings, using drilled rails and 3-step, 4-step or 5-step Mark the left edge of the centre holes in both the top and bottom rail [Figure 3].
- Page 2 Stair Rail Kit Continued Align the marks, holes facing together, and continue Insert a baluster with angled stair connectors the new line already scribed on the bottom rail along into each drilled hole in the bottom rail the top rail. Hold both rails up against the posts to [Figure 7].
- Page 3 Stair Rail Kit Continued Fasten the top rail to the posts with three To complete the stair railing, trim to length and angle screws through the pre-drilled holes in cut a 2x4 for handrail. (Tip: The angle of the cuts the clips [Figure 9].
- Page 4 [fig. 2]. fig. 1 1/4 po Avec le kit de rampe fig. 2 d’escalier Veranda, il devient facile de construire 1/4 po des garde-corps d’escalier en utilisant les traverses préforées et les limons d’escalier à 3, 4 ou 5 marches, préfabriqués et traités...
- Page 5 Kit de rampe d’escalier (suite) Alignez maintenant les marques, trous orientés les Insérez un balustre avec connecteurs d’escalier uns vers les autres, et prolongez la nouvelle ligne à angle dans chacun des trous préforés de la déjà tracée le long de la traverse supérieure. traverse inférieure [fig.
- Page 6 Kit de rampe d’escalier (suite) Fixez la traverse supérieure aux poteaux à Pour compléter le garde-corps d’escalier, installez l’aide de trois (3) vis engagées dans les trous un élément de 2x4, coupé à angle et fini à la préforés des cornières [fig. 9]. longueur, sur la traverse supérieure pour former la main courante.