Publicité
gate configurations (choose which best fits your scenario):
Measure the width of the opening where you intend to install the gate.
Refer to the following illustrations to determine the correct installation
configuration. Baseboard molding may change which configuration is
appropriate.
A
(29.5˝- 33˝) without extension frames
C
(37.5˝- 41˝) with large extension frame
E
(45.5˝- 49˝) with 2 large extension frames
Note: This instruction book
illustrates installation of gate
configuration F.
If choosing gate configuration A,
skip ahead to step 2. Otherwise,
follow step 1 using the
appropriate extension frames that
best fit your scenario.
(33.5˝- 37˝) with small extension frame
(41.5˝- 45˝) with large and small extension frame
(49.5˝- 53˝) with the 2 large and small extension frames
Important: Gate includes a door stop (part H)
which prevents the gate from swinging open
in one direction. When installing the gate at
the top of stairs, be sure that the door stop is
on the stairway side of the gate so the door
cannot open over the stairs. While the door
stop comes assembled on the gate, it can be
removed and installed on either side of the
gate frame.
When gate is not used at top of stairs, door
stop may be removed to allow gate door to
open in either direction.
WARNING
NEVER install three extension
frames on the same side of the
gate.
B
D
F
H
3
Publicité
