Publicité
C
20. Pick up the Left Door (I) and align the hinge bases to the pilot holes on the Left Side Panel (C).
21. Insert two 15 mm Nickel Screws (6) through the CENTER of oval holes and move the doors up or down
to the desired position, then fasten the Hinge Bases (N) into place.
22. Proceed to insert two 15 mm Nickel Screws (6) through the round holes and fasten into place.
23. Repeat the same process to attach the Right Door (J) to the Partition Panel (E).
24. Open and close the doors to make sure they are aligned and shut correctly. If necessary, adjust the screws
for a good fit. (Refer to the hinge sticker on door for adjustment).
C
25. Put the Paper Stickers (9) onto the visible cam locks to conceal the cams.
26. Stick the Rubber Bumpers (10) on the outer upper corners of doors where the Left Top Stretcher (F) is in
contact with.
Assembly Instructions
A
E
J
I
A
E
F
I
Oval hole
N
Round hole
DO NOT fully tighten the
D
J
13
Adjustment
Vertical
Adjustment
Horizontal
Adjustment
6
screws.
9
10
Depth
Publicité
