Reelcraft 30000 Serie Instructions D'opération page 3

Series 30000 Electric Motor Driven Reels
SERVICE INSTRUCTIONS
Replacing the hose
1. Using a wrench, firmly hold onto the fluid path while removing
hose connector.
2. Follow procedures for "Connecting the hose" (refer to
installation instructions).
Replacing the swivel
CAUTION: Remove supply line pressure before performing the
following procedure.
1. Remove supply line from swivel.
2. Remove swivel assembly from fluid path.
3. Install swivel assembly to inlet shaft by reversing steps 1 and
2. Apply thread compound to all threads.
Replacing the motor
CAUTION: Before replacing the motor, remove all electrical power
from motor.
1. Disconnect wiring lines from motor.
2. Remove (4) bolts securing motor mounting bracket to reel.
Remove bracket.
3. Remove defective motor from bracket.
4. Install new motor to bracket and remount to reel.
www.reelcraft.com
Replacing the chain
CAUTION: Before replacing the chain, remove all electrical power
from motor.
1. Loosen (do not remove) bolts securing motor mounting
bracket in place.
2. Remove chain master-link.
3. Remove chain master-link. Install new chain by reversing
steps 1 and 2 above.
Adjusting the chain tension
CAUTION: Before adjusting the chain tension, remove all electrical
power from motor. Over-tensioned (tightening) of chain results in
reduced motor life. Adjust to allow between 1/4 and 1/2 inch play
in chain.
1. Loosen (4) bolts (do not remove) securing motor mounting
bracket to reel.
2. Move motor mounting bracket and motor until proper chain
tension is obtained.
3. Tighten motor mounting bracket bolts.
Page 3