Publicité
Для експлуатації в Україні необхідно отримати дозвіл на експлуатацію у порядку, затвердженому
рішенням НКРЗІ від 01.11.2012 № 559, зареєстрованому в Міністерстві юстиції України
03.01.2013 за № 57/22589.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used
with the unit to ensure compliance.
Antenna Installation WARNING: It is the installer's responsibility to ensure that when using the
authorized antennas in the USA (or where FCC rules apply); only those antennas certified with the
product are to be used. The installer should configure the output power level of antennas, according to
country regulations and per antenna type. Professional installation is required for equipment with
connectors to ensure compliance with health and safety issues.
LIST OF APPROVED 2.4 GHz ANTENNAS:
21 dBi Parabolic Dish Antenna (MikroTik model: LHG XL-2)
18 dBi Parabolic Dish Antenna (MikroTik model: LHG-2)
10 dBi Dual Polarity, Directional Antenna (MikroTik model: LDF-2)
Publicité
