Publicité
Installations
Before installing your cellar, you must do the following:
•
Unpack both the exterior and interior layers of packaging. Verify the presence of all components listed in the
parts inventory, including shelves and instructional materials. Should any elements, such as shelf fragments or
support structures, become dislodged during transit, refer to the instruction manual for precise guidance on proper
installation.
•
Inspect the cellar for any signs of damage or deformation. If the cellar shows no signs of issues during inspection,
place it in the designated spot.
•
When moving your cellar, please do not incline it more than 45 degrees.
•
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight
may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause the unit to perform improperly. The optimal ambient temperature range is 64.4°
F(18°C) - 78.8° F(26°C) Avoid locating the unit in damp areas.
•
The cellar is designed for freestanding use. Ensure that there is 5cm of air space on both sides, and 8cm in back.
Place the unit on a flat, solid floor that is strong enough to support it when it is fully loaded. To level the appliance,
adjust the front leveling leg at the bottom of the unit.
•
Before connecting the unit to the power source, let it stand upright for approximately 8 hours. This will reduce the
possibility of a malfunction in the cooling system from handling during transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
Plug the wine cellar into an exclusive, properly installed and grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or electrical
grounding should be directed to a certified electrician or authorized products service center. After plugging the
appliance into a wall outlet, allow the unit to cool down for 3 to 4 hours before placing wine bottles in the cellar.
Anti-tip bracket installation
To avoid the risk of serious personal injury or damage to the appliance due to the instability of the appliance, it must
be fixed to the floor with anti-tip brackets and screws(supplied). Before installing, carefully read these instructions.
1. Take the fixing brackets(2pcs) and the expansion bolts(2pcs) out of the instruction packet.
2. Drill holes into the floor according to the dimensions shown below. This will allow you to fix the brackets to the
floor. According to the size and location, the holes on the floor should be Ø0.39" (10mm).
TIP: Use painter's tape to judge how deep of a hole you are drilling. First, cut a piece of painter's tape several inches long. Then,
place the tape on your drill bit at the depth of the expansion bolts shield to drill. Once you reach the tape, you know when to stop
drilling. Don't drill too deep.
12.52" (318mm)
8.07" (205mm)
Top View
13
Min: 0.87"/22mm
Max: 1.77"/45mm
Tape
Publicité
