Tool Specifications - DeWalt DWF83C Guide D'utilisation

Tool Specifications

MODEL
HEIGHT
WIDTH
LENGTH
WEIGHT
NOSE TO WALL DISTANCE
RECOMMENDED OPERATING
PRESSURE
AIR CONSUMPTION PER 100
CYCLES
LOADING CAPACITY
Nail Specifications
NOTE: Use only D WALT approved fasteners.
e
MODEL
NAIL LENGTHS
SHANK DIAMETERS
FASTENER COLLATION
NAIL TYPE
OPERATION
Preparing the Tool (Fig. 2, 3)
DWF83C
12.5" (317.5 mm)
4.95" (125.7 mm)
at the beginning of this manual. Always wear eye and ear protection
14.1" (358.5 mm)
when operating this tool. Keep the nailer pointed away from yourself
8.5 lb (3.85 kg) and others. For safe operation, complete the following procedures
and checks before each use of the nailer.
2.5" (64 mm)
70 - 120 psig
6.5 cfm
@ 80 psi
1 Coil (200-300 Nails)
DWF83C
2" - 3-1/4"
(50 mm - 83 mm)
.113" - .131"
(2.8 mm - 3.3 mm)
15° Coil
15° Round Head
6
WARNING: Read the section titled Important Safety Instructions
1. Before you use the nailer, be sure that the compressor tanks
have been properly drained.
2. Lubricate the tool following these directions:
a. Use D WALT pneumatic tool oil or a non-detergent S.A.E. 20
e
weight oil. DO NOT use detergent oil or additives as they will
damage o-rings and rubber parts.
b. Use a filter-regulator-lubricator in the air line between the
compressor and the tool when possible.
c. If a lubricator is not available, add 5 to 10 drops of oil in the air
fitting a least twice a day or every 4 hours of use.
FIG. 2
3. Wear proper eye, hearing and respiratory protection.
FIG. 3