Before the first use
· Start by carefully reading the instructions for use and the safety instructions.
· Then remove all packaging materials.
· Only wipe off the housing and the baking surfaces with a soft cloth (slightly
damp, if necessary). Attention: Do not use any abrasive cleansers when
cleaning!
· Heat up the empty device with closed lids for approx. 10 minutes. The slight
smoke and odor that will probably be occur is completely harmless. This is only
protective oil, which was applied during production. Ensure good ventilation
of the room during this period!
· Open the appliance to let it cool down and wipe the baking surfaces with a
slightly damp soft cloth.
Use
· Unwind the cable completely and place the appliance on a suitable surface
(not on a metal surface; not on fabrics, etc.).
· Ensure sufficient free space above and near the appliance to avoid overheating.
· Close the lid and insert the plug into a suitable socket. Turn the temperature
knob to level 5, the red indicator light switches on.
Attention: Ensure that the power cord does not touch any hot surfaces of the
housing.
· As soon as the pre-set temperature is reached, the green indicator light will
switch on. The waffle maker is now ready to use.
· The indicator light lights up until the waffle maker is disconnected from the
electricity.
· Open the lid and slightly grease all four baking surfaces with a highly heatable
oil.
· Attention: Using the device results in high temperatures, only touch the device
at the heat resistant handle. Risk of burns!
· Spread some dough in the middle of the two lower baking areas and close
the lid.
· Pay attention not to fill too much dough to prevent it from spilling over.
· After about 3-4 minutes, depending on the set temperature and the desired
browning, the waffles are finished. To check the browning carefully lift up the
lid to prevent the waffles from tearing. Depending on the desired browning,
you can leave the waffles in the waffle maker to let it brown a little more.
· You can set the temperature with the regulator – at the beginning, the
temperature can be a little bit higher and then subsequently reduced.
· The waffles are ready, as soon as the green indicator light is on. To take the
waffles out do not use any sharp or pointed metal accessories to avoid
scratching the non-stick coating.
· If necessary, slightly grease the baking surface in between.
· Especially during longer use some water condensation might produce. Dry it
off with an absorptive cloth.
· After use always pull the plug from the socket and open the appliance to let
it cool down.
Cleaning and care
· Always pull out the power cord before cleaning and allow the appliance to
cool down.
· Do not use any sharp or pointed objects, benzine, solvents, scrubbing brushes
or abrasive cleaning agents for cleaning.
· Wipe off the housing and the baking surfaces with a soft cloth (slightly damp,
if necessary).
· Attention: Never immerse the appliance, the cable or the plug in water or other
liquids and do not clean these parts in the dishwasher.
· Make sure that the device is completely dry before using it again or storing it.
7