Martin Logan Dynamo IW-O Manuel D'installation

Télécharger ce manuel

INSTALLATION FOR HIGH OUTPUT IN-WALL BACKBOX & DYNAMO IW-O SUBWOOFER

PARTS INCLUDED:

• 1 – Backbox

• 2 – Pre-Construction Brackets • 1 – Wire Loop with Screw

REQUIRED, NOT INCLUDED:

• 16 – #8 Wood Screws

(8 to attach brackets to box; 8 to attach box to wall)

NOTE: DO NOT PUNCTURE OR REMOVE PROTECTIVE PLASTIC OVER

CUTOUT UNTIL READY TO INSTALL SUBWOOFER.

IMPORTANT NOTE: The required amount of damping material is included and correctly positioned in backbox. DO NOT remove, compact

or add additional damping material. DO NOT add damping material to wall directly behind backbox.

BACKBOX DIMENSIONS

NOTE: Wire loop must be attached

with screw provided.

IMPORTANT! Backbox has been inverted.

DO NOT install in this position, see proper

position in Step 2.

STEP 1

INSTALLING BRACKETS

CAUTION: Mounting brackets are made

of galvanized steel. Edges may be sharp.

180˚

STEP 2

MARTINLOGAN DOES NOT SUPPLY SCREWS FOR MOUNTING

BACKBOX AND SUBWOOFER TO WALL. CHOOSE SCREWS

APPROPRIATE FOR WALL COMPOSITION AND WEIGHT OF

BACKBOX WITH SUBWOOFER.

DYNAMO IW-O IN-WALL SUBWOOFER: 14 lb/6.3 kg

DYNAMO IW-O BACKBOX: 17.6 lb/8 kg | TOTAL WEIGHT: 31.6 lb/14.3 kg

IF YOU ARE NOT COMFORTABLE PERFORMING THE FOLLOWING

PROCEDURE, CONTACT A PROFESSIONAL INSTALLER.

INSTALLING BACKBOX

To prevent vibrations and resonances from coloring output,

center the box between joists—backbox must not touch joists.

Terminal cup

sits here.

STEP 3

Page 1 DYNAMO IW-O IN-WALL SUBWOOFER: 14 lb/6.3 kg • 16 – #8 Wood Screws DYNAMO IW-O BACKBOX: 17.6 lb/8 kg | TOTAL WEIGHT: 31.6 lb/14.3 kg (8 to attach brackets to box; 8 to attach box to wall) NOTE: DO NOT PUNCTURE OR REMOVE PROTECTIVE PLASTIC OVER IF YOU ARE NOT COMFORTABLE PERFORMING THE FOLLOWING PROCEDURE, CONTACT A PROFESSIONAL INSTALLER.
Page 2 WIRING DRYWALLING RED (+) BLACK (–) Before drywalling, snake wire through wire loop then along wall to amplifier. STEP 4 STEP 5 INSTALLING SUBWOOFER INSTALLING GRILLE Holding the subwoofer’s front lip with your thumbs and index fingers, push the brackets can fit through the hole with an “up-and-in” motion. Release the screws and gently push the subwoofer into the backbox.
Page 3 BOÎTIER ARRIÈRE DYNAMO IW-O : 17,6 lb / 8 kg • 16 – vis à bois n CAISSON DE SOUS-GRAVES DYNAMO IW-O : 14 lb / 6,3 kg (8 pour fixer les supports au boîtier; 8 pour fixer le boîtier au plafond)
Page 4 RACCORDEMENT INSTALLATION DE LA CLOISON SÈCHE ROUGE (+) NOIR (–) Faire passer le fil dans la boucle pour filage puis le long du plafond jusqu’à l’emplacement de l’amplificateur avant d’apposer la cloison sèche. ÉTAPE 4 ÉTAPE 5 INSTALLATION DE L’ENCEINTE INSTALLATION DE LA GRILLE En tenant la bordure avant de l’enceinte avec les pouces et index, En tenant la bordure avant de l’enceinte avec les pouces et index,...