Reelcraft 30000 Serie Instructions D'opération page 2

Series 30000 Electric Motor Driven Reels
INSTALLATION INSTRUCTIONS
Inspection
Unpack and inspect the reel for damage. Turn the reel by hand to
check for smooth operation. Check for completeness.
Mounting of all hose reels
NOTE: Ensure that mounting surface is flat to prevent binding on
reel after it is mounted.
1. Two 1/2" diameter mounting holes are located at the base
of each side support panel (2 each). Mount reel using four
(customer supplied) bolts; tightening them securely to ensure
a solid, rigid attachment.
2. Perform the following steps only after all other installation
steps, pertaining to your particular reel, are accomplished.
NOTE: A flexible hose connection must be used to compensate
for any offset between the supply line and the reel swivel.
3. Apply thread compound to all threads.
4. Thread male connector of supply line into swivel. Tighten
securely.
CAUTION: Remove all electrical power when wiring. Do not
"hot-wire". Observe all applicable NEC/OSHA requirements.
5. Ensure that supply and motor voltage ratings are compatible.
6. Consult wiring diagrams and determine which one is
applicable to your reel.
7. Perform electrical wiring following applicable diagram.
Connecting the hose
CAUTION: Do not connect the hose to the fluid path until after
hose reel has been installed. Fully extend and pressurize hose
before winding on to reel. Momentarily open control valve, when
initially pressurizing, to purge hose of gases. When fluid appears at
control valve, close valve. This prevents flattening of the hose and
excessive pressure on the drum when fluid supply is reinitialized
at a later time.
Page 2
1. Apply thread compound to all threads.
2. Hand thread male hose connector into fluid path.
3. Using a wrench, firmly hold onto fluid path while tightening
hose connector.
OPERATING INSTRUCTIONS
WARNING-PREVENT STATIC
SPARKING: When working around flammable liquids such as
solvents, paints, chemicals or petroleum products, ensure that the
hose reel, hose and the equipment being serviced are properly
grounded. Use grounded hose(s) (static wire). Use an ohmmeter
to check continuity of the ground circuit. Fire and/or explosion
can result if proper grounding is not achieved. Be careful of chain/
sprocket drive system. Keep hands clear. Do not wear loose fitting
clothing. Pull hose from the reel by grasping the hose itself, not
the control handle or swivel.
www.reelcraft.com