Publicité
OPERATION
4. Press the
button to turn on the unit.
• The
button will illuminate green, the LED display
will show the current temperature of the unit, and
preheating will begin.
5. Using a heat-resistant brush, carefully apply an oil-based,
non-stick shortening evenly onto each grill plate.
6. With the grill plates closed, allow the unit to preheat for
approximately 8–10 minutes.
• When preheating is complete, three short beeps will
sound and the LED display will show the current timer
setting.
7. Lift open the top grill plate, place food product onto the
bottom grill plate, and close the top grill plate onto the food
product.
Handle
Top
Grill Plate
Bottom
Grill Plate
Grease
Trap
Panini Grill in open position
8. Press the
button to start the timer. Refer to "Adjusting
the Timer Setting" in this section to change the timer setting.
9. When cooking is complete, several beeps will sound and
the LED display will flash zeros.
• Touch the
button to reset the timer.
10. Carefully lift open the top grill plate completely, and
remove the food product.
NOTE: The timer can be reset and restarted at any time by
pressing the
button.
11. Use the included grill scraper to clean the grill plates
between food product or as needed.
• Scrape crumbs into the grease trap at the front of the
unit. Carefully empty the grease trap as needed.
Standby Shutdown
Use standby shutdown to put the unit in standby mode during
extended periods of non-use.
1. Press the
button to shut down operation and put the
unit into standby mode. The light will be red.
• The heating elements and LED display will shut down.
Daily Shutdown
Use the following procedure to shutdown the unit at the end of
each day.
1. Press the
button to shut down operation and put the
unit into standby mode.
2. Move the Power I/O switch located on the back of the unit
to the O (off) position to turn off power to the unit.
3. Perform the "Daily Cleaning" procedure in the Maintenance
section of this manual.
Changing Between Fahrenheit and Celsius
1. Make sure the unit is in standby mode. Refer to the
"Standby Shutdown" procedure in this section.
2. Press and hold the
• The LED display will show either "F" or "C" to indicate
the active unit of measure.
Adjusting the Temperature Setting
NOTE: If the
buttons are not pressed within seven
seconds during programming, the unit will revert to
showing the current timer setting without making any
changes.
1. With the unit in operating mode, press the
• The LED display will show the current setpoint
temperature.
2. Press the
or
setting to the desired setpoint temperature.
3. Press the
button three times to lock in the new
setpoint temperature and return the display to operating
mode.
NOTE: The unit will operate normally during the temperature
adjustment period after a setpoint temperature change.
Adjusting the Timer Setting
NOTE: If the
buttons are not pressed within seven
seconds during programming, the unit will revert to
showing the current timer setting without making any
changes.
1. With the unit in operating mode, press the
times.
• The two characters that represent "minutes" will flash on
the LED display.
2. Press the
or
setting to the desired number of minutes.
3. Press the
button.
• The two characters that represent "seconds" will flash
on the LED display.
4. Press the
or
setting to the desired number of seconds.
5. Press the
button to lock in the new timer setting and
return the display to operating mode.
8
English
button for three seconds.
button to increase or decrease the
button to increase or decrease the
button to increase or decrease the
PGM-0724
button.
button two
Publicité
