Publicité
English
General
Hatco Panini Grills are designed for ease of operation and
versatility. Use the following information and procedures to
operate a grill.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
Control Panel
The following are descriptions of the controls used to operate
a Panini Grill. Controls are located on the control panel as well
as on the back of the unit.
Power I/O Switch
The Power I/O (on/off) switch controls power to the unit. It is
located on the back of the unit. Use the Power I/O switch for
daily or long-term shutdown of the unit.
LED Display
The LED display shows time, temperature, and error information
for the unit.
Standby Button
The lighted Standby button (
operating mode and standby mode. Use standby mode for short-
term shutdown of the unit.
• In standby mode, the light will be red.
• In operating mode, the light will be green.
Time/Temperature Button
The Time/Temperature button (
through temperature and time settings.
Arrow Buttons
The Arrow buttons (
temperature settings.
• Press the
button to increase a time or temperature
setting.
• Press the
button to decrease a time or temperature
setting.
Enter Button
The Enter button (
) starts, stops, and resets the timer.
Standby Button
Time/Temperature Button
PGM-0724
) toggles the unit between
) toggles the LED display
) are used to change time and
LED Display
Operating the Unit
Startup
1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICATIONS section for details.
NOTE: The unit is preset at the factory to a temperature of 386°F
(197°C) and a timer setting of 3:30. The temperature
range of the unit is 220°–500°F (104°–260°C). The
timer setting range of the unit is 0:10–10:00. Refer to
procedures in this section to make adjustments to these
settings.
2. Make sure the grease trap is in position and the top grill
plate is down in the closed/operating position.
Top Grill
Plate
Assembly
Handle
Grease
Control
Trap
Panel
BURN HAZARD:
• Some exterior surfaces on unit will get hot. Avoid
unnecessary contact with unit.
• Do not come in contact with grill plates during
operation. Both plates are very hot.
3. Move the Power I/O switch located
on the back of the unit to the I (on)
position to turn on power to the unit.
• A beep will sound, the LED
display will flash, and the light on
the
button will illuminate from
amber to red.
Arrow Buttons
Enter Button
Control Panel
7
OPERATION
Power I/O
Bottom
Grill Plate
Model PG14G-1
CAUTION
Switch
(on back)
Power I/O
Switch
continued...
Publicité
