TOOL SPECIFICATIONS
All screws and nuts are metric.
MODEL
LENGTH
HEIGHT
WIDTH
WEIGHT
TU-216-2330
9.06" (230.1mm)
7.81" (198.4mm)
1.60" (40.6mm)
2.17lb. (.984kg.)
FASTENER SPECIFICATIONS:
MODEL
HEADLESS
GAUGE
FASTENER RANGE
MAGAZINE
PIN SERIES
CAPACITY
TU-216-2330
S700
23
3/8"- 1-3/16" (9-30mm)
200 PINS
TOOL AIR FITTING:
This tool uses a free-flow connector plug, 1/4" N.P.T. The minimum inside diameter should be .200" (5mm).
The fitting must be capable of discharging tool air pressure when disconnected from the air supply.
OPERATING PRESSURE:
70 to 100 p.s.i. (4.9 to 7.1 kg/cm2). Select the operating pressure within this range for best fastener
performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
Model TU-216-2330 requires 1.86 cubic feet per minute (.053 cubic meters) of free air to operate at the rate of
100 fasteners per minute, at 80 p.s.i. (5.6kg/cm2). Take the actual rate at which the tool will be run to determine
the amount of air required. For instance, if your fastener usage averages 50 fasteners per minute, you need
50% of the tool's c.f.m. of free air which is required for running at 100 fasteners per minute.
-4-