Publicité
17
17
10
EN
Remote Control Pairing and Connecting
Make sure that the power is turned off.
Ÿ
After confirming that the power is off, proceed to turn on the device again.
Ÿ
Press and hold the switch button on the remote control for about 5 seconds until you see the LED light start flashing.
Ÿ
Once the LED light starts flashing, it indicates that the remote control has been successfully paired. Now, you can now control the lights with the
Ÿ
remote control.
Note: If you encounter any issues during the operation, please refer to the manual or contact our customer support team for assistance.
Blue
Cyan
Cyan
White
White
Brightness +
Brightness -
Light Switch
(The memory function allows the light
to remain at the mode you last set)
Blue
Red
Red
Breathing Light Mode/Constant Light Mode
Purple
(Initial state: Constant Light Mode )
RGB
Purple
RGB
(The light is red on the sides and
transitions to blue in the center)
(Gaming Light Effect)
Blue
Cyan
Red
White
Purple
RGB
24
Open the battery compartment
to replace the battery
(Battery model: CR2025)
Publicité
