Publicité
EN
Use
IMPORTANT: The wires in the mains lead are colored in
Blue – Neutral
As the colors of the wires in the mains lead of this appliance may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows:
The blue wire must be connected to the terminal marked with an N or colored black. The brown wire must
be connected to the terminal marked with an L or colored red. The green/ yellow wire must be connected
to the earthing terminal which is marked with an E or with the earth symbol.
NOTE: If a moulded plug is fitted and has to be removed take great care in disposing of the plug and
severed cable, it must be destroyed to prevent engaging into a socket.
WARNING: Never connect live or neutral wires to the earth terminal of the plug.
Troubleshooting
You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the service centre.
Problem
The heater does not
operate, even when it is
plugged in and the switch,
thermostat are switched
on.
The heating element
glowing.
The appliance didn't heat
up, or only ventilator
worked.
Abnormal noise.
5059340130361_MNL_IN_V04.indd 29
5059340130361_MNL_IN_V04.indd 29
accordance with the following code:
Brown – Live
Possible cause
The plug is loose, bad
connection.
No power in socket
outlet.
The input voltage is
too high or too low.
The air inlet grill is
blocked.
The switch was not
put at heating setting.
The thermostat
operated.
The self-resetting
cut-out operated.
The appliance is not
stands upright.
Green/Yellow – Earth
Treatment
Pull out the plug, check the connection of the
plug and socket. Then connect again.
Insert the plug in a proper socket.
Use power supply according to the rating on the
label.
Keep the heater far way from articles like
curtain, plastic bag, paper and other things
which can cover the inlet or can be easily cover
on the air inlet.
Turn the switch to heat setting.
Turn the thermostat and listen if there is
open/close voice. If there is no click and the
thermostat is not damaged, the heater will
automatic switch on when the appliance cooled
down.
Turn the heater off and inspect the blockage of
inlet or outlet. Disconnect the plug and wait at
least 10 minutes for the protection system to
reset before attempting to restart the heater.
Put the heater on a level surface.
29
24-08-2024 17:21:15
24-08-2024 17:21:15
Publicité
