Publicité
EN
Use
Installation Instructions of Cable Reel
Reel
Thumb screw
1.
Take out of the cable reel pieces reel (2 pcs) and thumb screw (2 pcs) out of the packing box.
2. Put the machine on a relatively flat table, Insert the strips of the cable reel metal pieces in the vertical
notches and overlap each hole with those of the rear screen. Then fasten the pieces with thumb screw,
as shown in Figure 4.
Note: If screwing is not smooth, unscrew and start again to fit with the thread.
3. The assembled cable reel is shown in Figure 5.
WARNING: This product must only be operated in an upright position.
WARNING: The cable can't be un-winded on the reel during heater is in running, it
5059340130361_MNL_IN_V04.indd 27
5059340130361_MNL_IN_V04.indd 27
Rear screen
Figure 4
should be fully unraveled before using the heater.
Figure 5
24-08-2024 17:21:14
24-08-2024 17:21:14
27
Publicité
