Publicité
8.2 Condensed water (Fig. 1)
Important! To ensure a long service life of the
pressure vessel (2), drain off the condensed wa-
ter by opening the drainage cock (11) each time
after using.
Check the pressure vessel for signs of rust and
damage each time before using. Do not use the
compressor with a damaged or rusty pressure
vessel. If you discover any damage, please con-
tact the customer service workshop.
8.3 Safety valve (10)
The safety valve is set to the maximum permissib-
le pressure of the pressure vessel. It is not permit-
ted to adjust the safety valve or remove its seal.
It should be pressed from time to time to check
the function. To check the safety valve, carefully
unscrew the screw cap while the boiler is pres-
surized. When opening the cap, air will escape at
the valve. After you have opened the screw cap,
screw it back on completely.
8.4 Cleaning the intake fi lter (1)
The intake fi lter prevents dust and dirt from being
sucked in. It is necessary to clean this fi lter at
least every 300 hours of operation. A clogged in-
take fi lter signifi cantly aff ects the performance of
the compressor. First remove the cover by sliding
it up, then open the fi lter half (Fig. 7, 7a). Then
blow out all parts of the fi lter with compressed air
at low pressure (approx. 3 bar) and assemble the
fi lter in reverse order.
When cleaning, take adequate precautions
against dust (e.g. use a suitable face mask).
8.5 Storage
Warning!
Pull the mains plug out of the socket and ventilate
the appliance and all connected pneumatic tools.
Switch off the compressor and make sure that it is
secured in such a way that it cannot be started up
again by any unauthorized person.
Warning!
Store the compressor only in a dry location
which is not accessible to unauthorized per-
sons. Always store upright, never tilted!
8.6 Transport
•
Transport the equipment only by carrying it by
the transport handle.
•
Protect the equipment against unexpected
knocks and vibrations.
Anl_TE_AC_270_50_Silent_SPK13.indb 17
Anl_TE_AC_270_50_Silent_SPK13.indb 17
GB
8.7 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 17 -
11.04.2024 11:45:58
11.04.2024 11:45:58
Publicité
