Télécharger Imprimer la page

EINHELL TE-AC 270/50 Silent Instructions D'origine page 14

Publicité

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
Explanation of the symbols used (see Fig. 8)
1. Danger! - Read the operating instructions to
reduce the risk of injury.
2. Caution! Wear ear-muff s. The impact of noi-
se can cause damage to hearing.
3. Beware of electrical voltage!
4. Beware of hot parts!
5. Warning! The unit is remote-controlled and
may start-up without warning.
6. Overload switch
7. Protect against moisture.
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Warning!
Read all the safety information, instructions,
illustrations and technical data provided on
or with this power tool. Failure to adhere to the
following instructions may result in electric shock,
fi re and/or serious injury.
Keep all the safety information and instruc-
tions in a safe place for future use.
This appliance is not intended for use by persons
(including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
Anl_TE_AC_270_50_Silent_SPK13.indb 14
Anl_TE_AC_270_50_Silent_SPK13.indb 14
GB
2. Layout and items supplied
2.1 Layout (Fig. 1-4,7)
1. Intake air fi lter
2. Pressure tank
3. Wheel
4. Supporting foot
5. Quick-lock coupling (regulated compressed
air)
6. Pressure gauge (for reading the preset tank
pressure)
7. Pressure regulator
8. ON/OFF switch
9. Transport handle
10. Safety valve
11. Drainage cock for condensation water
12. Pressure gauge (for reading the tank pressu-
re)
13. Quick-lock coupling (unregulated com-
pressed air)
14. Non-return valve
15. Overload switch
16. Accessory bracket
17. Socket head screw for accessory bracket
18. Acorn nut for accessory bracket
19. Air fi lter cover
20. Wheel cap
21. Axle screw
22. Nut
23. Flat washer M6
24. Flat washer M8
25. Compressed air hose bracket
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
Open the packaging and take out the equip-
ment with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until
the end of the guarantee period.
- 14 -
11.04.2024 11:45:57
11.04.2024 11:45:57

Publicité

loading

Ce manuel est également adapté pour:

40.104.51