Publicité
3. Intended use
The machine is designed for the sanding of wood,
metal, plastic and similar materials using the
appropriate sanding paper. The equipment is not
suitable for wet sanding.
The equipment is allowed to be used only for its
prescribed purpose. Any other use is deemed to
be a case of misuse. The user/operator and not
the manufacturer will be liable for any damage or
injuries of any kind resulting from such misuse.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be voided
if the equipment is used in commercial, trade or
industrial businesses or for equivalent purposes.
4. Technical data
Motor power supply: ............................ 18V
Idling speed: .................................. 0-11000 RPM
Oscillating speed: .......................... 0-22000 OPM
Sanding area: ........................................ 4'' x 4
Abrasive paper size
(Hook-and-loop fastener): ...................... 4'' x 4
Abrasive paper size (Clamp fastener): ..4
Orbit diameter: ...............................................
Weight (Tool only): .....................................2.4 lbs
Wear ear-muff s.
The impact of noise can cause damage to
hearing.
Reduce noise generation and vibration to a
minimum!
•
Use only equipment that is in perfect
condition.
•
Maintain and clean the equipment regularly.
•
Adapt your way of working to the equipment.
•
Do not overload the equipment.
•
Have the equipment checked if necessary.
•
Switch off the equipment when not in use.
Anl_TE_OS_18_113_Li_NA_SPK7.indb 11
Anl_TE_OS_18_113_Li_NA_SPK7.indb 11
EN
CAUTION!
Residual risks
Even if you use this electric power tool in
accordance with the instructions, certain
residual risks cannot be eliminated. The
following hazards may arise in connection
with the equipment's construction and
layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear
protection is applied.
3. Health damage caused by hand-arm
vibrations if the equipment is used over a
longer period or is not properly guided and
maintained.
Limit the operating time.
All stages of the operating cycle must be
considered (for example, times in which the
electric tools are switched off and times in which
the tool is switched on but operates without load).
5. Before starting the equipment
⁄
"
1
2
Warning!
Always remove the battery pack before making
⁄
"
1
adjustments to the equipment.
2
⁄
'' x 5
⁄
"
1
1
2
2
⁄
"
Be sure to read the following information before
5
64
you put the cordless equipment into operation:
•
Charge the battery pack with the charger
(battery and charger not included). An empty
battery pack requires a charging period of
approximately 0.5 to 1 hour.
5.1 Fitting the dust collection box (Fig. 2/
Item 4)
•
Fit the dust collection box (4) on the dust
extraction adapter (2) by turning it gently as
far as the notch as shown in Fig. 2.
•
The dust is extracted directly through the
abrasive paper and the sanding disc into the
dust collection box.
•
Remove the dust collection box in reverse
order.
•
Using the dust extraction adapter (2) you
can also connect the equipment directly to a
suitable vacuum cleaner (Fig. 3).
- 11 -
12.08.2024 13:58:09
12.08.2024 13:58:09
Publicité
