Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Operating
Start up
(page 4)
When power-up, the BRIGHT shows consecutive.
Software version information
1
Bronkhorst High-Tech logo
2
Readout screen
3
Keep contrast and screen saver time low for longer display life-time.
!
Select « Readout »
Press
or
to toggle between 'measure readout', 'custom readout 1' and 'custom readout 2'.
Press
return direct to 'measure readout'
CANCEL
You can press
SET
If 'custom readout1' is disabled. You can only switch between 'measure' and 'custom readout 2'
!
The displayed readout parameters and values are depending on custom settings and the connected instrument.
!
Change « Custom Readout 2 »
Press
to change the readout parameter of 'custom readout 2'. Press
CANCEL
parameter.
Some readout parameters have their own sub-menu. Select 'custom readout 2' and press
submenu.
You can only select parameters which are supported by the connected instrument.
!
Edit setpoint
(page 4)
From the main readout menu, Press
'custom readout 2'. Press
to abort the edit mode.
CANCEL
If the entered setpoint is neglected, check controller mode in the settings-controller mode menu.
!
Enter the security settings
From the readout screen press both
is 'abc'. Please refer to 'Security settings' of the Instruction Manual for more information.
Doc nr.: 9.17.049
(page 4)
to enter the sub-menu below the selected readout.
(page 4)
to change 'custom readout 2' into "setpoint" menu. Press
CANCEL
to enter the setpoint edit mode. Use
SET
and
for 5 seconds till 'enter password' display appears. The default password
again to select the next available
CANCEL
,
and
to edit the setpoint value. Press
SET
7/16
to enter its
SET
to select
Publicité
Table des Matières
