Publicité
4. Select "Wi-Fi Repeater" from the main menu
5. Unless already enabled, select the Wi-Fi
switch "Enable" and press "Apply"
6. Remove the PC-Router connection with the
ethernet cable
7. Select "Wi-Fi Internet"
8. "Wi-Fi hotspot" appears: this section of
the menu lets you manage available Wi-Fi
sources. If the desired Wi-Fi source is not pre-
sent, use the "Add" button to search for avai-
lable sources
9. At the end of the search, select the Wi-Fi
source you wish to repeater
10. Enter the password of the selected network
and press "Apply"
11. Select, again, the network you wish to repea-
ter and press the "Connect" button.
At the end of the connection procedure the Wi-
Fi network that was bridged is used to connect to
and browse the internet. Connection to the Wi-Fi
network for browsing purposes is confirmed by the
Wi-Fi connected symbol with a dual grey arrow
pointing at a mobile device symbol in the "Signal"
column of the list of available Wi-Fi sources.
6.5 Internet access via the WAN port
1. Connect the WAN port on the back of the rout-
er to the Ethernet socket via an Ethernet ca-
ble with an RJ45 connector.
2. Configure the access parameters for the PP-
PoE/Static/DHCP internet network.
Rev.002
6.6 Enable/Disable PIN
1. From the main menu, disable the connection
by shifting the switch in the "Connection sta-
tus" box to "off"
2. In the top menu bar, select "Advanced Set-
tings"
3. Select "Others" and then, on the page, select
"Manage PIN". You can use this section of the
menu to enable/disable the PIN
4. After making the changes go back to the main
page and re-enable the connection by setting
the "Connection status" switch to the "ON" po-
sition.
WLT24EX
Translation of the original instructions
EN
- 9 -
Publicité
