Publicité
6.
SWITCHING ON THE WLT24EX
1. Press and hold the ON/OFF button for 3 sec-
onds to switch off the router.
2. Insert the SIM CARD, as shown in
3. Connect the power cable.
4. Press the ON/OFF button and wait for the
router to connect to the mobile phone net-
work of the operator associated with the SIM
CARD.
EN
Insert or remove the SIM CARD with the
router switched off. If the router is on,
the SIM CARD may be damaged and
become unusable.
The LEDs on the front panel provide indications
on the operational status of the router.
LED
Status
Power supply
SYS
On: Power supply present
Off: Power supply not present
RF
Indication of the RF signal reception strength
On: WiFi enabled
WiFi
Off: WiFi not enabled
Flashing: user connected
On: LAN or PC connection
ETH
Off: Not connected with LAN or PC network
Flashing: Data transfer
Wireless connection status indicator
On: Connected to the network
NET
Off: Not connected to the network
Flashing: data transfer
Tab. 1 - WLT24EX LED status indicators
6.1 Configuration
Configure the router using the Graphical User In-
terface (GUI) accessible via web browser by typ-
ing the address http://192.168.100.1.
Use the following login credentials to access the
configuration panel:
Username: admin
Password: admin
- 8 -
All the information for the GUI connection, the
user address, password and IP router is displayed
on a label on the back of the router.
Fig. 2.
6.2 APN configuration
For some telephone operators it is necessary to
manually configure the APN (Access Point Name)
address in order to access the internet.
1. Select the "Network settings" menu.
2. Select APN.
3. Set to Manual mode and select "Add new".
6.3 Connecting to the WiFi network
The login credentials for the router WiFi network
are:
SSID: WLT24EX Teleco WiFi 4G xxxx
Password: 1234567890.
6.4 Wi-Fi Repeater configuration
The Wi-Fi Repeater function lets you connect the
router to an available Wi-Fi source (e.g. the Wi-Fi
signal made available by the campsite) and use it
to browse the internet..
To connect:
1. If the router Wi-Fi network - WLT24EX_xxxx -
2. Access the WLT24EX GUI by opening the
3. Enter the required password. Default pas-
WLT24EX
Translation of the original instructions
Once you have entered, change the pass-
word to prevent unauthorized access.
Now enter the APN address of the used oper-
ator. Once the data has been saved the router
will, if it is correct, enable access to the inter-
net.
Change the SSID and WiFi network ac-
cess password using the GUI, in order to
prevent unauthorized access.
is not available, connect the router to the PC
with the ethernet cable
browser and entering the 192.168.100.1 in
the address bar
sword is "admin"
Rev.002
Publicité
