Hilti TE 800-AVR Mode D'emploi page 14

Trouble or fault
The power tool doesn't
start.
The power tool doesn't start
and the service indicator
lights red.
No hammering action.
The power tool doesn't
start.
The power tool starts and
the service indicator lights
red.
9
Possible cause
The control switch is defective.
Generator in sleep mode
The carbon brushes are worn.
A fault has occurred in the tool.
The power tool is too cold.
A fault has occurred in the tool.
Electronics initialization in
progress (takes up to 1 second
after plugging in) or the
electronic restart safety interlock
has been activated after an
interruption in the electric
supply.
Interruption in the electric sup-
ply.
The supply cord or plug is defec-
tive.
The control switch is defective.
Generator in sleep mode
The service indicator lights.
Action to be taken
▶
Have the power tool checked
by a trained electrical special-
ist and the carbon brushes
replaced if necessary.
▶
Apply a load to the generator
by connecting a second power
consumer (e.g. worklight).
▶
Have the parts checked by
a trained electrical specialist
and replaced if necessary.
▶
Have the tool repaired by Hilti
Service.
▶
Bring the tip of the drill bit
or chisel into contact with
the workpiece and allow the
power tool to run under no load
until it reaches the minimum
operating temperature.
▶
Have the tool repaired by Hilti
Service.
▶
Switch the power tool off and
then on again.
▶
Plug in another power tool or
appliance and check whether
it works.
▶
Have the parts checked by
a trained electrical specialist
and replaced if necessary.
▶
Have the power tool checked
by a trained electrical special-
ist and the carbon brushes
replaced if necessary.
▶
Apply a load to the generator
by connecting a second power
consumer (e.g. worklight).
▶
Have the power tool serviced
or repaired by Hilti Service.
2064796
*2064796*