Publicité
INFLATING OPERATING INSTRUCTIONS
• Connect the flexible conduit adaptor (11) to the inflation inlet (1) on the pump and twist clockwise to tighten.
• Connect the air tap (10) to the valve of the inflatable and twist clockwise to fix it into position.
• Plug the DC plug into a 12V DC power supply.
• Press the
button to toggle between the units and select the unit you require.
• Use the
and
• Press the
to start to inflate.
• During the inflating process you can adjust the pressure value and units if required.
• When the pump reaches the set pressure value, it will stop automatically.
• The pump can be stopped at any time by pressing the
• Once inflating is complete remove the DC plug from the power supply, remove the hose from the pump and store it safely.
Notes
• On the first use the factory set pressure is 10PSI or 0.7BAR. The next time you use the pump it will remember the last set
pressure value used.
• If the pump is left switched on after 2 minutes it will go into standby mode. To start using the pump again press the
button.
DEFLATING OPERATING INSTRUCTIONS
• Connect the flexible conduit adaptor (11) to the deflation outlet (2) on the pump and twist clockwise to tighten.
• Connect the air tap (10) to the valve of the inflatable and twist clockwise to fix it into position.
• Press the
to start to deflate and again once deflating is finished.
FAULT FINDING
Fault
1. The power source is not plugged properly.
The air pump
2. The fuse in DC plug (3) is burnt out.
won't start
3. Overheating or overload causes motor stop.
1. Check whether the hose is blocked or
Slow or
cracked.
abnormal
2. The joint between the hose and air pump or
inflation or
air bag is not installed properly.
deflation.
MAINTENANCE & STORAGE
• Before carrying out any maintenance on the pump, ensure that it is unplugged from any power source.
• Allow to cool before storing in a cool dry place.
WARRANTY
Fox offer a one year warranty against defects in material or workmanship, beginning on the date of purchase (valid only in
conjunction with your purchase receipt). The warranty does not extend to wearing parts as their life is subject to use and
conditions which can vary.
DECLARATION OF CONFORMITY
Hereby, Fox International Group Ltd declares that the Fox Electric Air Pump CIB032 is in compliance with
(EU) Electromagnetic Compatibility - Directive 2014/30/EU (UK) Electromagnetic Compatibility Regulations 2016.
The full text of the UK and EU declaration of conformities are available under the support menu at: www.foxint.com
eurocustomerservices@ratheroutdoors.com
4
buttons to set the required pressure value between 0 to 20PSI (0 to 1.4BAR).
Inspection
button.
Solution
1. Make sure that the DC plug is fitted correctly into the 12V DC socket.
2. Change the fuse.
3. Cool the motor and restart it.
4. If the problem cannot be solved, please contact your retailer with
proof of purchase.
1. Change the hose or unblock it and check whether the hose is
cracked.
2. Reinstall the hose.
3. If the problem cannot be solved, please contact your retailer with
proof of purchase.
Publicité
