Publicité
Resetting Your Change Filter Indicator
Note: These are the most common filter reset instructions. If the instructions don't work for your
refrigerator brand, see the documentation that came with your refrigerator.
Refrigerator brand
GE
or Hotpoint
®
Kenmore
®
Filter Features
• Economical alternative to expensive substitutes
• Easy installation and operation
• Provides cleaner, fresher water by reducing impurities
• Designed to provide up to 6 months of life or 300 gallons
• Does not remove minerals which may be beneficial to health
NOTE: This filter should not be used with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
Frequently Asked Questions
Q: Why is it difficult to twist the new filter into the filter housing?
A: The connector may expand because of water pressure. Therefore, it is recommended you push
the new filter in with a little bit of force, but not too hard. Then turn it clockwise.
Q: Must the filter be changed every 6 months?
A: Yes. You must replace the filter every 6 months or sooner if water flow is reduced or if there is
heavy sediment/rust sediment. Over-used filter will degrade the filtration performance.
Q: Do I need to flush the filter after installation?
A: After installation, it is highly recommended you run water from dispenser for 5 minutes before
using. Water filters are made from advanced coconut carbon block, so there are some carbon
fines in the filter. Flushing removes the carbon fines to produce clean water.
6
Instructions
Press and hold the reset water filter button on the dispenser for
®
three seconds.
The water filter reset for Kenmore refrigerators varies by model.
See the documentation that came with your refrigerator.
Publicité
