Publicité
Instructions for use: 5512 infrared thermometer
This infrared thermometer has the particularity of easily and quickly measuring the surface temperature while programming an alarm that can
have 3 different limits in relation to the reference temperature (+/‐0.5°C, +/‐3°C or +/‐5°C).
1.
Key features
Built‐in laser pointer
Backlit LCD screen
3 temperature tolerances
Temperature alarm
Low battery indicator
Maximum and minimum temperature
recordings
Adjustable emissivity 0,1 to 1,0
Auto‐off after 20 seconds
°C/°F Selection
3.
Using the device
1.
To measure the temperature, point the thermometer at the area to be measured and press the trigger. The « SCAN » icon will appear.
2.
Alarm temperature (reference): by default the temperature is set to 0°C.
To modify this : first, press and hold the trigger, then press the « SET » button while holding the trigger. The « REF »
indicator will flash. Release the buttons. Press and hold one of the D « left » or E « right » buttons (see the drawing
on the right) to change the alarm temperature. Press « SET » to confirm.
The device will remember the reference temperature until the battery is changed. To modify the reference again, repeat the procedure.
3.
To set the alarm threshold: turn on the device and press the « left » or « right » button to select the desired tolerance: +/‐0.5°C, +/‐
3°C or +/‐5°C relative to the reference temperature. To disable the reference temperature function: select the « OFF » icon.
4.
Alarm: The measured temperature will automatically be compared to the selected reference temperature with the chosen limit.
‐
If the measured temperature remains within the selected range: the screen will be green.
‐
If the temperature exceeds the limit: the screen will turn red and beep quickly (if the trigger is held).
‐
If the temperature is below the limit: the screen will turn blue and beep slowly (if the trigger is held).
‐
If the alarm is set to "OFF" : the screen will appear yellow
4.
Settings:
To choose the measurement unit (°C or °F): press the "SET" button.
To adjust the emissivity: press and hold the "SET" button for 3 seconds, then adjust the emissivity using the « left » and « right »
buttons. Press "SET" again for 3 seconds to save the selected emissivity. Note: The default emissivity is set to 0,95.
5.
Battery replacement:
When the low battery icon appears
To do this, open the battery compartment, replace the 9V battery and close the battery compartment cover.
18/10/2024 / V2
2.
Device Description
A.
Laser pointer beam
B.
Infrared sensor
C.
LCD screen
D.
« Left » button
E.
« Right » button
F.
« SET » button
G.
Measurement trigger
H.
Battery compartment
, replace the device's battery.
STIL – 254 rue Foch – Vaux le Pénil – France – www.stil.fr
Screen
1.
Low battery indicator
2.
« SCAN » icon
3.
Measurement result
4.
« REF » function activated or not
5.
Defined values
6.
Temperature units
7.
Temperature reference
8.
« REF » Icon
or
Publicité
